energylifearmor.blogg.se - Create a bootable usb on a mac for windows

CREATE A BOOTABLE USB ON A MAC FOR WINDOWS INSTALL
CREATE A BOOTABLE USB ON A MAC FOR WINDOWS DRIVERS
CREATE A BOOTABLE USB ON A MAC FOR WINDOWS FULL
CREATE A BOOTABLE USB ON A MAC FOR WINDOWS PC

When Windows finally boots up, you will need to enter all information as if this really was a new, fresh installationĪll that is from here, but it applies in this situation a well, since you would be moving a Windows 7 installation from one computer to another.

One or two reboots are needed, depending on your system specifications You will notice Windows booting as if it was the first boot after installation, installing default and updating registry.

CREATE A BOOTABLE USB ON A MAC FOR WINDOWS PC

Boot the PC from sysprep generalized hard disk.

Sysprep generalizes now your Windows 7 setup and shuts down your computer.ĭo not run any other programs during this phase!.

In sysprep dialog that opens, choose “System Cleanup Action” as “Enter System Out-of-Box-Experience (OOBE)”, select “Generalize”, and select “Shutdown Options” as “Shutdown”.

Type to Command Prompt: %windir%\System32\Sysprep\Sysprep.exe, and hit Enter.

CREATE A BOOTABLE USB ON A MAC FOR WINDOWS DRIVERS

Once it is up and running (don't worry about drivers yet), follow these steps.

CREATE A BOOTABLE USB ON A MAC FOR WINDOWS INSTALL

Put your Windows 7 installation disc into the Mac optical drive, and install Windows 7 on that drive. One method that will work is to swap the hard drive out of the PC and into the Mac.

I can find other copies of Live USB helper out there, but they are all Windows executables. that article may prove useful, but probably not. after you read all that, on the Gizmodo page it says that if you want to make it bootable you should use a utility called Live USB helper they link to (which isn't there any more) and use a Mac mounting tool (which isn't there either!) to force the ISO to mount on the Mac so you can copy the files over. Run diskutil eject /dev/disk N, and remove your flash media when the command completes (this can take a few hours on slower drives) Run diskutil unmountDisk /dev/disk N (replace N with the disk number from the last command in the previous example, N would be 2)Įxecute sudo dd if=/path/to/downloaded.iso of=/dev/disk N bs=1m (replace /path/to/downloaded.iso with the path where the image file is located for example. Run diskutil list and determine the device node assigned to your flash media (e.g., /dev/disk2) Here are some instructions from Gizmodo that will put the ISO onto the flash drive with a Mac. To format the partition, type format fs=ntfs quick, and then click ENTER.OK. To select the partition that you just created, type select partition 1, and then click ENTER. To create a new primary partition on the USB flash drive, type create partition primary, and then click ENTER. This command deletes all data from the USB flash drive. Note the drive number or drive letter of the USB flash drive.Īt the command prompt, type select disk, where X is the drive number or drive letter of the USB flash drive, and then click ENTER. The list disk command displays all the disks on the computer. In the new command line window that opens, to determine the USB flash drive number or drive letter, at the command prompt, type list disk, and then click ENTER. Open a Command Prompt window as an administrator. Insert a USB flash drive into a running computer. Restore or repair your server running Windows Server Essentials

CREATE A BOOTABLE USB ON A MAC FOR WINDOWS FULL

Restore a full system from an existing client computer backup To create a bootable USB flash drive for use in recovering or reinstalling Windows on a PC instead of a server, see Create a recovery drive.įor additional scenarios in which you may want to create or use a bootable USB flash drive, see the following topics: